CT125 Fuel capMagnet holder – U4944625948

Description

-[Contents]-
Neodymium magnet
Installation Screw
Non-slip sheet for cap protection

**[Installation notes]
Basically, it attaches to the Phillips head screws under the seat of the CT125 Hunter Cub.*See image
All you need is a screwdriver to remove the default Phillips-head screw.
However, please read the following instructions carefully before proceeding.
The neodymium magnets used in this product are thin by specification, so there is a possibility that the magnets may break if they are tightened too much during installation.
Be careful not to over-tighten the magnet when the top of the magnet and the head of the screw are flat.

*Please note that specifications are subject to change without notice due to improvements, modifications, or material procurement.
*There are cases that it contains other product in the photo.
*Please note that the product specification may change due to manufacturer reasons..

Fuel capMagnet holderKit for CT125CT110 HUNTER CUB from KEMEKO!.
Eliminates a little frustration when refueling.. Even the service station staff were impressed!
When I remove the cap, I just put it down and it doesn’t roll around..

Magnet magnetically holds fuel cap securely in place even when in Side Stand.
Easy installation with a 1 pc driver and a protective non-slip sheet to prevent damage to the vehicle and cap..
The CT110 HUNTER CUB has a de-fault hole, but if you have a 4mm hole (or can open one) for other vehicles, you can install either resin or gold..