3M Dinoc Film – U4944611304

Description

carbon fiber tone
Size: 1220x1000mm

What is 3M Dinoc Film?
It is made of fully professional vinyl chloride resin, so durability is outstanding!
The printed film with adhesive can be easily cut with a cutter or scissors.
It can be easily stretched by heating it with a hair dryer, etc., so it can be attached to three-dimensional curved surfaces!
EA type adhesive
DYNOC film uses EA type adhesive with lattice-shaped air release grooves on the adhesive surface.
Air bubbles in between the base material and the film are ejected along the grooves, so that it is possible to apply the film to a large area or a complicated surface quickly, and the degree of perfection of the finish is further improved.

[Assembly example]
Check the size and cut it in larger size.
Wipe the surface clean.
Be sure to remove oil residue.
Gently peel off the release paper to prevent dust from sticking and apply the carbon film over.
Make it stick by pressing it down with your finger.
Use a squeegee to remove the air.
If the concave and convex parts are warmed up by a hair dryer, it will be finished beautifully.
While the warmed film is soft, align the corners and fold the film inward so that it wraps around the corners.
Please cut the unnecessary part of film neatly.
The film can be reapplied by adding some heat.
Pay attention not to overheat it.

Specific primer